This group has helped me a lot in installing my M1 so I like to share when I learn something new that I think may be helpful.
I have been tinkering with and adding to my system via ElkRP/xep for a week or so now with no malfunctions until this morning. Every time I would connect to the xep with ElkRP it would be fine for about thirty seconds and then disconnect from the xep with the message "control has disconnected".
Long story short..... after an hour of troubleshooting I remembered that last evening I installed a trial version of CQC to see what it looked like. I uninstalled CQC, rebooted and my ElkRP has been successfully connected for a half hour with no disconnect.
Hope this saves someone some time, Mike.
I have been tinkering with and adding to my system via ElkRP/xep for a week or so now with no malfunctions until this morning. Every time I would connect to the xep with ElkRP it would be fine for about thirty seconds and then disconnect from the xep with the message "control has disconnected".
Long story short..... after an hour of troubleshooting I remembered that last evening I installed a trial version of CQC to see what it looked like. I uninstalled CQC, rebooted and my ElkRP has been successfully connected for a half hour with no disconnect.
Hope this saves someone some time, Mike.