Need help with wiring

[martinsbt]

Ok, i am using the channnel vision 8 ports Punchdown module with 8 RJ45 connector. I punched my wires following the colors on the module...
I am using keystone RJ45 jacks at the other end (wallplate). i understand that there are 2 different standard (A and but the colors order shown on the channel vision doesnt seem to match any of these 2 standard.... so what do i do? i am confused!!! please help

thanks in advance

Martin

 

[electron]

Channelvision modules follow A, it should say it right on there, assuming you are talking about the module you can see in this picture.

 

[martinsbt]

Ok, i am using the channnel vision 8 ports Punchdown module with 8 RJ45 connector. I punched my wires following the colors on the module...
I am using keystone RJ45 jacks at the other end (wallplate). i understand that there are 2 different standard (A and but the colors order shown on the channel vision doesnt seem to match any of these 2 standard.... so what do i do? i am confused!!! please help

thanks in advance

Martin

Yes! thanks Dan! i also called Robert from AARTECH where i bought the module from (what a great service they give by the way) and he confirmed to me the same thing! They use standard A. Also, on my module, there was no mention of the standard that theu are using (maybe design was changed)

ANyway

thanks Again

 

[TCassio]

The difference between A and B is that the orange and green pairs are swapped.