Premise New User - needing Nuvo T2 and Concerto driver

[Sparks]

It's been about 4 years since I used Premise and am still amazed how advanced it is...even today. Too bad Motorola gave up on it. Anyway, I've wandered back to it and was looking for the Nuvo T2 driver and any driver for the Nuvo Concerto. I saw in a tread that there was one for the Grand Concerto....and that may do if the source is available. I'm not really a programmer....but have done a little programming in the past. Any idea where I might find those drivers?

 

[georgejm]

I just reposted the Nuvo Grand Concerto and T2 tuner modules.

 

[Sparks]

WOW....thanks for the quick response. I do have a question with the NUVO drivers. I've loaded them and they seem to respond to commands (ie. off/on, etc) from Premise...however, Premise doesn't seem to find the state the devices are in. Are these only one way drivers for some commands? I'll admit I haven''t spent a lot of time on this yet...but when I turn a zone off or turn off a tuner....Premise doesn't seem to know that. It's odd...because I do see RDS data in the LastRXCommand for the NV-T2DF object and I can see the frequency change in each tuner when I change it from the NUVO keypad. Also, I see the RDS info on the NV-T2DF object and not on the separate TunerA or B object. Since the Concerto driver is for the Grand Concerto and not Concerto...I can see where there may be some changes needed for it.

 

[georgejm]

The Nuvo Tuner module is designed with the premise (pardon the pun) that Premise is the only controller in the system. Changes via keypad (other than on/off) won't be reflected in Premise.