Hi Guys
I'm thinking of making the switch to Premise (currently using Elve)
I have an Arduino Unu which I programmed with RF codes to control a number of plugin outlets.
Its coded to look for simple serial commands which then send the corresponding RF signal.
for example,
if "a" is received it turns on outlet 1
if "A" is received it turns off outlet 1
If "b" is received it turns on outlet 2
and so on
I'm sure there is a much better way to do this but I'm very new to Arduino so I just stuck with what worked first.
It is quite easy to send serial commands with Elve but I'm having trouble getting it to work in Premise
I was hoping to create a new device(serial) with power state on/off, then assign my serial data to the on and off but I've been unsuccessful so far.
Any suggestions would be much appreciated
Thanks
Mike
I'm thinking of making the switch to Premise (currently using Elve)
I have an Arduino Unu which I programmed with RF codes to control a number of plugin outlets.
Its coded to look for simple serial commands which then send the corresponding RF signal.
for example,
if "a" is received it turns on outlet 1
if "A" is received it turns off outlet 1
If "b" is received it turns on outlet 2
and so on
I'm sure there is a much better way to do this but I'm very new to Arduino so I just stuck with what worked first.
It is quite easy to send serial commands with Elve but I'm having trouble getting it to work in Premise
I was hoping to create a new device(serial) with power state on/off, then assign my serial data to the on and off but I've been unsuccessful so far.
Any suggestions would be much appreciated
Thanks
Mike