Hi,
I have an M1 Gold installed in my house for 9+ years now. It works really well and have been expanding it a bit at a time. This past week all motion detectors were triggered at the same time for no apparent reason. They are all hard-wired onto my first 16-port expansion board (zones 18, 22, 24, 28, 30 and 31) and have been that way since 2007. I thought there might be insects in the panel, so I cleaned everything out and hard-started the system. Everything seemed to be fine and then all motion detectors tripped again! I now have the alarm enabled in the Stay mode so no motion detectors are enabled.
Any advice? Do I need to replace the input board?
Thank you!
Gary
I have an M1 Gold installed in my house for 9+ years now. It works really well and have been expanding it a bit at a time. This past week all motion detectors were triggered at the same time for no apparent reason. They are all hard-wired onto my first 16-port expansion board (zones 18, 22, 24, 28, 30 and 31) and have been that way since 2007. I thought there might be insects in the panel, so I cleaned everything out and hard-started the system. Everything seemed to be fine and then all motion detectors tripped again! I now have the alarm enabled in the Stay mode so no motion detectors are enabled.
Any advice? Do I need to replace the input board?
Thank you!
Gary