Programing X-10 Two-Way Interface

[DeputyDawg]

On my OMNI II Pro board I used a PSC05 to interface with my X-10 devices using the programing feature in Dealer PC Access 3.  However, my PSC05 went bad and there are none to be found.  I tried to find a TW523 which is a like module to the PSC05 with the same negative results.
 
Are there any other types of modules available anymore that are used in lieu of these?  Any if not, what are your recommendations to continue being able to turn on/off lamps, etc., through my OMNI II Pro board and Dealer PC Access 3?
 
TIA
 
DDawg

 

[RAL]

Get a XTB-523.  It's an improvement over the original X10 design, and is available assembled or in kit form if you're handy with a soldering iron and want to save a few bucks.

 

[BLH]

I would second the XTB-523 replacement.
I have see reports of happy uses with that replacement.