SpaceCowboy
Active Member
Going over the documentation to the TR-40 I'd like to add the outside temperature sensor but it suggests I need to physically cable it from the Wall Display Unit (WDU).
As this was a retrofit, I don't have enough free pairs to run it from my WDU. Can I cable it any other way? Is this outside sensor a RS-485 device? Could it therefore be attached to the RCS controller instead of the WDU?
Anyone have a configuration like this?
As this was a retrofit, I don't have enough free pairs to run it from my WDU. Can I cable it any other way? Is this outside sensor a RS-485 device? Could it therefore be attached to the RCS controller instead of the WDU?
Anyone have a configuration like this?