I have existing 120V wired smoke alarms with battery backup throughout my house.
However, I would like my panel to monitor for fire and CO in order to protect my house from fire and CO as well as trying to protect my dog if a fire starts when no one is home.
I was planning on the System sensor 2TWA-B (smoke and 135 head) and COSMO2W (smoke and CO).
The attached plans show the location of my current smokes in red, and the smoke/CO unit is red/blue.
Any suggestions for placement? I read a bit about placement, but I didn't know how things change when I am also using the 120V sensors. Should I add a sensor one in the attic? Crawlspace?
Only slightly related should I use FPL, FPLP or FPLR wire. I am going up about 6 feet from my panel which is flush mounted into the attic and then all the wiring will be up there. I guess the 6 feet up is considered a riser so I should use FPLR, but wasn't sure.
Thanks!
However, I would like my panel to monitor for fire and CO in order to protect my house from fire and CO as well as trying to protect my dog if a fire starts when no one is home.
I was planning on the System sensor 2TWA-B (smoke and 135 head) and COSMO2W (smoke and CO).
The attached plans show the location of my current smokes in red, and the smoke/CO unit is red/blue.
Any suggestions for placement? I read a bit about placement, but I didn't know how things change when I am also using the 120V sensors. Should I add a sensor one in the attic? Crawlspace?
Only slightly related should I use FPL, FPLP or FPLR wire. I am going up about 6 feet from my panel which is flush mounted into the attic and then all the wiring will be up there. I guess the 6 feet up is considered a riser so I should use FPLR, but wasn't sure.
Thanks!