]A bunch of my HLC switches weren't working so I decided to "rebuild" my UPB Network. I've gotten them all setup again with UPStart but they can't be controlled with my Omni Pro II.
I was careful to match the UPB UID with the Unit# in PC Access (See 1st Attached Shot). This Knowledge Base article on setting up on "Applying HAI Lighting Control (HLC)" is entirely unhelpful since the description of step to PCAccess don't match up at all with the UI of the version I've got (For Instance, there's no such thing as Setup>>Micellaneous>>Control).
Th only thing I wasn't sure about what whether the Network ID in UPStart is supposed to match the UPB Network Address in PCAccess (See 2nd attached pic)
What else could I be missing to setup set switches with my panel?
Are there any decent documents on UPB device setup with PC Access?
I was careful to match the UPB UID with the Unit# in PC Access (See 1st Attached Shot). This Knowledge Base article on setting up on "Applying HAI Lighting Control (HLC)" is entirely unhelpful since the description of step to PCAccess don't match up at all with the UI of the version I've got (For Instance, there's no such thing as Setup>>Micellaneous>>Control).
Th only thing I wasn't sure about what whether the Network ID in UPStart is supposed to match the UPB Network Address in PCAccess (See 2nd attached pic)
What else could I be missing to setup set switches with my panel?
Are there any decent documents on UPB device setup with PC Access?