politics123
Active Member
Nice find... but no way to directly integrate with an ELK, right?
Nice find... but no way to directly integrate with an ELK, right?
I really don't know enough about the CR9380-NPN to tell you why it is not working. I would have used the CR9380-ACA. Perhaps someone else has an idea.
Steve Q
When you "ran the power cable through it" I hope you only put one leg of the circuit through the coil! It will not work if both the hot and the neutral wires both run through the coil. You need to separate the wires and run only one through.
BSR - My camera is lent out at the moment so I can't get a pic right now.
Hey Martin, I just have a quick question about your set up....
You ran your space heater thru a CR9380-NPN. How many times did you have to wrap the wire thru your CR9380-NPN ?
Also, are you using any other stuff in your setup? ie...burden resistors? Did you just run the wires from your CR9380-NPN directly to your DS10a?
Where did you guys get your short extension cables from? Just a local supply store or something?
Thanks,
B
btw -- I still haven't gotten the NX650 route to work. Not sure why...
btw -- I still haven't gotten the NX650 route to work. Not sure why...
Not sure how it works on the Elk but on a Caddx panel you need to program the Nx650 differently to allow the use of the external wire leads. I think it also will disable the internal reed switch. Not an answer but hopefully a clue! Have you tried the Nx650 with just an standard magnetic sensor to see if that works?