Wiring UltraProx ELK-106055 to KP2

[dbinaz]

I got the wrong harness from AO, so I am making my own. The instructions don't list anything about the KP2, so, since there are only 2 pins on the input on the KP2, what do they go to on the Prox reader? and where do the other wires go? tap into existing KP power lines?

Thanks,
D

 

[Spanky]

Look at page 3 of the M1KP2 manual. M1KP2 Manual

You will see the wiring diagram for the Prox reader and the appropriate wiring harness. You could probably find a two pin, .1 inch spacing wiring connector at Radio Shack.

 

[dbinaz]

damn, RTFM. I have stuff spewed all over the place so if I don't see it, I forget about it.
Any thanks again!!

D

 

[dbinaz]

so i took the 5 pin ahrness and cut it in half, shaved it down a bit and fits no prob.