Recent content by RonX

Honeywell Webstat http://customer.honeywell.com/BuildingsMarketing/Cultures/en-US/Automation+Systems/WebStat+Controller/default.htm Proliphix Professional Series http://www.proliphix.com/products-network-professional.htm Proliphix Commercial Series...

Maybe this http://hacs.com/ab8ss.php but is not cheap

http://www.geeks.com/details.asp?invtid=PL-1000-PB&cpc=SCH $299 6 USB ports and the best part: 4 Serial ports Microsoft Windows Embedded POSReady 2009 pre-installed. What is the difference between POSReady 2009 and Windows XP Professional? * Windows Embedded POSReady 2009 contains the...

Then, can anyone confirm if the ControlThink stick flashed with the latest firmware, can work with the Leviton Installer Tool? Because the Leviton FAQ states this: 12.) Can I convert my ControlThink USB ThinkStick to a Vizia RF + Installer Tool USB stick? No, the USB sticks are configured...

BSR, have you looked at the CNB "Monalisa" cameras? they are highly regarded as a true day night and low cost cameras by the guys at the CCTV forum

You can use Hauppauge HDPVR with DVBLink for HDPVR, or with the native Hauppauge Media Center drivers, check DVBLogic forums or thegreenbutton forums

Sorry for the little off-topic. Is there a way with this board to sense the status of a LED? I'm not an electronic guy, but what would happen if I wire the LED in parallel with one of the WebControl analog input, along with the VDC signal that will turn on the LED? Does the LED will turn on and...

Is there a way with this board to check if voltage is going to a LED without interfering to the LED operation? How do I need to wire it? I'm planning to check the status of an APC surge protection device.

Do you need serial control? There is a IP controlable 4 outlet switch, Aviosys IP Power 9258, you can find it cheaper than $115.

Wayne Dalton Store has it listed at $64.95, but unavailable. http://www.waynedaltonstore.com/wayne-dalton-controllers.php

You could use a HDFury2 with any of your proposed component input solutions, including HD-PVR, problem solved

Do you mean that the NX-584 board is not required to program the NX8 with a PC? What about the RS232 ASCII commands to control the panel? Could you post the cable schematics? Regards

I was looking at the same thing a while ago and I did't found any Z-Wave switch (with relays in order to work with CFL) that doesn't require a neutral

You are looking at their dimmer section, the switch section is http://www.leviton.com/OA_HTML/ibeCCtpSctD...;minisite=10024, they work with any kind of lighting.

For the guys that had a main breaker near the meter and the main panel inside the house, should not be any issues, right?