If you are just looking to monitor loads with the capability of having a relay contact open or close on a predetermined setpoint then you could cobble together a hard wired circuit using CR Magnetics current sensing relays.
I believe the largest sensor relay unit is rated for 100A.
See...
Brian,
Tenholde's Homeseer plug-in does this for me. I have had my HS application down and PC off for a day at times and any accumulated KWH were retieved and updated once HS was re-started.
I am not sure how much memory the 1240 has and how long it would retain the information though.
Will
UJ,
Does it come with a serial port redirector software?
I have both a lantronix and a silex serial to ethernet convertor and either work fine with the 1240. I redirected a com port to TCP-IP address, set serial port for 19,200, 8, N, 1 and it works great.
Will
I do not use the etherbee but remember reading this early on in the forum.
Maybe it will help?
http://www.cocoontech.com/forums/index.php...st&p=110655
Glad you figured it out. You had me stumped.
I also extended my CT's around 60' with no problem. I took actual load readings on Sunday and compared to what HS was reporting and was within 2%. Good enough for me.
I also saved a extra CT on each of my 240V balanced loads by asking tenholde to...
UJ,
Just a thought. Do you have more than one micro CT on one of those Aux channels?
I found my polarity off when I had more than one CT on a channel and it reported more than actual on the 1240. I used an amprobe to obtain actual current draw on the circuits to straighten out the CT polarity...
Brian,
Tenholde's plug-in has been working great in it's beta stage since it was released a couple of weeks ago. Ed is adding more features to it weekly.
I have been using with HS Touch and so far it is playing well together. I created meter graphics for each load monitored and use textboxes...
I upgraded my version of tenEcmServer and tenHSPlugin last night and woke up to this and quite a few of these errors today while working in homeseer, usually one right after another. If I exit the error it shuts down HS.
So I have been clicking continue button. No harm, but it is starting to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.