I am just getting started with a newly installed ELK M1G. Can one of you tell me if I can do the following. (a sprinkler automation)
I would like set up a rule to have one of the M1 outputs occur for 15 minutes every day and continue to repeat each day without futher input. I want to launch this rule by pressing a function button on my keypad. I would like to also stop the rule until further notice by pressing a function button (preferrably the same button, like a toggle). And for the ultimate can I get the function button to light up when the rule is active and turn off if the rule is stopped?
The scenario, I want to automate a sprinkler. I would normally let it run day in and day out. But one in a while like last week, we get a tropical storm that provides 15 inches of rain in a Weekend and it would be great if a single button push could stop the sprinkler until we dry out, then with a single button push start again?
I would like set up a rule to have one of the M1 outputs occur for 15 minutes every day and continue to repeat each day without futher input. I want to launch this rule by pressing a function button on my keypad. I would like to also stop the rule until further notice by pressing a function button (preferrably the same button, like a toggle). And for the ultimate can I get the function button to light up when the rule is active and turn off if the rule is stopped?
The scenario, I want to automate a sprinkler. I would normally let it run day in and day out. But one in a while like last week, we get a tropical storm that provides 15 inches of rain in a Weekend and it would be great if a single button push could stop the sprinkler until we dry out, then with a single button push start again?