Hi,
I have an NX-8E system with a NX-148E panel. I have installed it and programmed it up fine with the panel, however I have been unable to connect the DL900 software to the serial port interface.
So far I have:
Connected the comm port 2 of the computer through a serial - NX-8E connector (5x2 hole connector) The plug goes on both ways so I have tried both (anyone know which way up it goes??)
I have turned on the serial port and set it to 9600bps
I have setup the software to comm2, 9600bps and binary (the default of the NX-8E).
Every time I try to connect it says that it takes about 45 sec and then gives an error "error writing data to module number 0...0"
Can anyone see what I am doing wrong or offer any advice on how to get it connected.
Thanks
Glen
I have an NX-8E system with a NX-148E panel. I have installed it and programmed it up fine with the panel, however I have been unable to connect the DL900 software to the serial port interface.
So far I have:
Connected the comm port 2 of the computer through a serial - NX-8E connector (5x2 hole connector) The plug goes on both ways so I have tried both (anyone know which way up it goes??)
I have turned on the serial port and set it to 9600bps
I have setup the software to comm2, 9600bps and binary (the default of the NX-8E).
Every time I try to connect it says that it takes about 45 sec and then gives an error "error writing data to module number 0...0"
Can anyone see what I am doing wrong or offer any advice on how to get it connected.
Thanks
Glen