SGUPTA0001
Member
I just decided to install the ELK m1 GOLD that I purchased 5 years ago from Smarthome. The basic installation was easy; I had ADT and wanted to use all of the Honeywell Sensors. The ELK M1 Gold install doc was very helpful - the only problem I have is that after I enroll the Honeywell sensors with the "LRN" process and use the ELK-RP (Ver 2.0.16) to receive all of the devices into the database - the process is automatically changing the "WIRELESS GROUP-2" to "Hardwire -Exp 2" and I don't have any zone expanders except the Wireless M1XRF2h and I don't have any control or config for the M1DBH - can anyone help ? I have been working with the dealer - but its remains unresolved.
Model: M1G HW: 0.11 BOOT: 3.3.6 Firmware 5.2.10 Address N/A
M1KP-2 HW: 1.4 Boot 3.0.14 Firmware 2.1.54 Address 1
M1XRF2H HW: 4.1 Boot: 1.0.0 Firmware 0.9.8 Address 2
M1EXP HW: 1.0 Boot: 1.2.0 Firmware 1.3.28 Address N/A
I also have the M1DBH inside the control panel - its connected and seems to be powering up the KEYPAD and the WIRELESS receiver with homerun CAT-5 but this device does not appear in the ENROLL/Update process of the ELK RP interface - Is that normal?
Model: M1G HW: 0.11 BOOT: 3.3.6 Firmware 5.2.10 Address N/A
M1KP-2 HW: 1.4 Boot 3.0.14 Firmware 2.1.54 Address 1
M1XRF2H HW: 4.1 Boot: 1.0.0 Firmware 0.9.8 Address 2
M1EXP HW: 1.0 Boot: 1.2.0 Firmware 1.3.28 Address N/A
I also have the M1DBH inside the control panel - its connected and seems to be powering up the KEYPAD and the WIRELESS receiver with homerun CAT-5 but this device does not appear in the ENROLL/Update process of the ELK RP interface - Is that normal?