SGUPTA0001
Member
I am trying to configure the Honeywell 5800RP with the ELK M1 - what is the TX ID ? The ELK-M1XRF2H manual is missing some details all it says is:
All I have is on the 5800RP are two sets of numbers: RF 00 0016 AB0C and A 085 7551 I am assuming that one of these are truncated to make the TXID? Why isn't that published in any document or website ? Please help !!!Manually type in the Xmtr ID of the 5800RP from ElkRP or from the Keypad. This device CANNOT be
enrolled via the learn method. Enroll as a ordinary transmitter and set its Loop type to a 1. THIS IS VERY IMPORTANT! Set the
Enable Supervision to a 1. Leave all the DIP switches on the 5800RP set to OFF. Power up the 5800RP and replace the cover. THE
TAMPER SWITCH MUST BE CLOSED in order for the zone assigned to the 5800RP to become secure. The 5800RP cannot repeat
the signal of another sensor unless it is functioning and its M1 zone is in a secure state. I.E. If the 5800RP tamper becomes activated,
or if the 5800RP loses total power, any transmitters that rely on it for communications to the control will become inoperable. This is the
reason why it is important for the 5800RP to be programmed as a working zone, and that it be set for periodic supervision