I am on the verge of purchasing an ELK M1G to replace my existing home control solution. I am currently using a W800RF32A interface for wireless comms to X10 devices and a LynX-10 PLC for wired communication to X10 devices. Does anyone know if the M1G will support either of these interfaces?
I read in the Elk forum (back in september) that the w800RF interface had been written and would be released soon. Does anyone know what the release date may be for this firmware?
I was hoping to use the Lynx10PLC via the on-board lighting interface connector (J5). The J5 connector states that is will support a PSC05 or equivalent, but I don't know if the Lynx10PLC will qualify. Has anyone successfully used a Lynx10PLC with the M1G?
Thanks in advance for any feedback!
Joey
I read in the Elk forum (back in september) that the w800RF interface had been written and would be released soon. Does anyone know what the release date may be for this firmware?
I was hoping to use the Lynx10PLC via the on-board lighting interface connector (J5). The J5 connector states that is will support a PSC05 or equivalent, but I don't know if the Lynx10PLC will qualify. Has anyone successfully used a Lynx10PLC with the M1G?
Thanks in advance for any feedback!
Joey