Latching Trouble Zone?

[nemesis]

I have installed System Sensors combined smoke and CO unit (COSMOD2W) in my OmniPro II setup.  It has a smoke/co maintenance zone which will signal me if any of the smoke/co detectors need maintenance.  I assumed that this should be a Trouble zone, however am running into issues because the COSMOD2W is on a Switched power to reset it.  Because of this the maintenance should be on some form of latching zone.  Any suggestions?

 

[Del91574]

If you run it on a 24 hr aux type it should latch irregardless, no?

 

[john999]

Nemesis--what did you end up doing for your trouble zone? I just installed my cosmod2w on my omnipro and am getting phone calls from the monitoring company every time I arm my system telling me the trouble zone tripped.

 

[knuckles]

john999 - how did you resolve this?  I am planning an install and am concerned about how the reset will work after it is armed.  

 

[john999]

I ended up just placing it on an aux zone, with good intentions of having the system notify me some other way when it trips for a certain amount of time...havent gotten around to that one yet.

You definitely cannot run it on the trouble zone.