Up to now I've been planning to go exclusively with UPB for lighting control in our new house. (Just beginning rough-in at the moment) However, I've seen enough positive comments about Centralite's LiteJet system that I'm now giving it some last-minute consideration.
I would plan to use the LiteJet for the first floor of the house where scene control is most needed and the floorplan is wide-open. (And where I'll also have several dimming fluorescent fixtures that might cause problems for UPB.) I figure I'd use UPB for the basement and second floor (each floor has about 24 loads), but I have some questions on how this would work. For reference, I'm planning on using the Elk M1G as well.
A) Would I be able to have a UPB switch manipulate some of the loads that are controlled by the LiteJet system?
B) Conversely, would I be able to set up a button on a LiteJet keypad that also controlled some loads on my two "UPB floors"?
Also, would it make any sense to have the electrician run the load wiring past the boxes where the LiteJet keypads would be, leaving an extra loop of wire before running off to where the LiteJet panel is located? That way, if I ever wanted to ditch the LiteJet I could always cut the load wire and insert a conventional switch.
Thanks,
JonR
I would plan to use the LiteJet for the first floor of the house where scene control is most needed and the floorplan is wide-open. (And where I'll also have several dimming fluorescent fixtures that might cause problems for UPB.) I figure I'd use UPB for the basement and second floor (each floor has about 24 loads), but I have some questions on how this would work. For reference, I'm planning on using the Elk M1G as well.
A) Would I be able to have a UPB switch manipulate some of the loads that are controlled by the LiteJet system?
B) Conversely, would I be able to set up a button on a LiteJet keypad that also controlled some loads on my two "UPB floors"?
Also, would it make any sense to have the electrician run the load wiring past the boxes where the LiteJet keypads would be, leaving an extra loop of wire before running off to where the LiteJet panel is located? That way, if I ever wanted to ditch the LiteJet I could always cut the load wire and insert a conventional switch.
Thanks,
JonR