Hello!
I have an Omnistat connected to my Omni IIe. Connected to Zones 9-13 are five relays (not PESMs) connected to 4 storage heaters and my underfloor heating. Right now the relays are not connected to any outputs on the controller, but I would ideally like to be able to switch the relays on or off dependent upon the room temperature (and ultimately remotely to turn them on and off as I drive up to the house, but thats later). I will also install some temperature sensors closer to a couple of the storage heaters to give more granular control, but the principle remains the same. I appreciate I need to connect the relays to an Output (as per instructions as if they were PESMs I assume?) but how do I achieve the switching on/off of the relays?
Or am I approaching this all wrong?
Thanks
Marc
I have an Omnistat connected to my Omni IIe. Connected to Zones 9-13 are five relays (not PESMs) connected to 4 storage heaters and my underfloor heating. Right now the relays are not connected to any outputs on the controller, but I would ideally like to be able to switch the relays on or off dependent upon the room temperature (and ultimately remotely to turn them on and off as I drive up to the house, but thats later). I will also install some temperature sensors closer to a couple of the storage heaters to give more granular control, but the principle remains the same. I appreciate I need to connect the relays to an Output (as per instructions as if they were PESMs I assume?) but how do I achieve the switching on/off of the relays?
Or am I approaching this all wrong?
Thanks
Marc
