Hey guys.,
I have been running an Omnistat2 down stairs and a regular Honeywell upstairs with no issues.
I found an Omnistat2 on ebay for $150 so I grabbed it and installed it using the same wiring configuration as downstairs, set the address to "2", and configured it in PC Access.
In the settings both are set to conventional.
I set the heatpoint to 72 and went to bed.
When we woke up this morning it was 76 and the heat was still blowing. I turned it to off and as of 5 minutes ago, it is still blowing hot air.
I'm going to just kill the power to the main unit to get this to stop for now but what could be the problem?
Here are pics of the setup
I have been running an Omnistat2 down stairs and a regular Honeywell upstairs with no issues.
I found an Omnistat2 on ebay for $150 so I grabbed it and installed it using the same wiring configuration as downstairs, set the address to "2", and configured it in PC Access.
In the settings both are set to conventional.
I set the heatpoint to 72 and went to bed.
When we woke up this morning it was 76 and the heat was still blowing. I turned it to off and as of 5 minutes ago, it is still blowing hot air.
I'm going to just kill the power to the main unit to get this to stop for now but what could be the problem?
Here are pics of the setup