Squintz
Senior Member
Here is what I have
Elk M1G->DataBus Expander->Serial Expander->W800RF --- <-EagleEye Motion
When I connect the W800RF directly to my pc and use the WGL Demo software I get messages as expected. My text input for the elk should be 0600^M^J and 0604^M^J which is how I have it setup. I have a rule to turn on a Z-Wave light.
I set the jumpers to what I think is correct on the Serial Expander. ElkRP recognizes that the Serial Expander exist so communications with the serial expander is good. I have it jumpered to RS232 and the manual says the baud rate does not need to be set.
But for some unknown reason when I trigger the EagleEye motion sensor the Elk event is not firing.
What could the problem be?
Elk M1G->DataBus Expander->Serial Expander->W800RF --- <-EagleEye Motion
When I connect the W800RF directly to my pc and use the WGL Demo software I get messages as expected. My text input for the elk should be 0600^M^J and 0604^M^J which is how I have it setup. I have a rule to turn on a Z-Wave light.
I set the jumpers to what I think is correct on the Serial Expander. ElkRP recognizes that the Serial Expander exist so communications with the serial expander is good. I have it jumpered to RS232 and the manual says the baud rate does not need to be set.
But for some unknown reason when I trigger the EagleEye motion sensor the Elk event is not firing.
What could the problem be?