I’m trying to integrate a Fibaro zwave flood sensor into my Elk M1. I have lights/receptacles all nicely controlled using VRCOP and M1. I have a couple new areas that I want to add flood sensors but can’t run wiring to those areas so was trying zwave sensor. I was able to add the fibaro to my network and can read what’s coming in on the VRCOP (using putty) when it senses water, but if I try to add an automation rule using WHENEVER REC TEXT in my M1, it is not sensing the message. Anyone have experience with this?
Fibaro with VRCOP
- Thread starter susanc
- Start date
ASIHome
Active Member
Not something I tried on an ELK panel but when I wanted to use Z-Wave sensors on my Omni panel, I had to split the output of the VRC0P to 2 separate serial ports and set the 2nd port as a standard (PROLINK on Omni) port. There may be something similar that has to be done with the M1.
Similar threads
