Flush-mount indoor temp sensors & controllers

I'm planning to install turn-key (I'm not gonna build anything) flush-mount indoor temperature sensors into my bathrooms soon for automation of turning on heaters in the morning on cold days. It doesn't look like there's any flush sensors that are directly compatible for an Elk M1 Gold?? (If I'm wrong, please let me know as that would be ideal!!)

If I'm forced to add another controller to the HA system (which will all be running under CQC eventually), so far I've seen folks reference the Qkit/VK011.

Would these sensors work for the Qkit VK011?

www.automated1.com/tspot.html

Check out the 3rd one down -- the ATS2000D. After clicking the ATS2000D link, be sure to click the PDF link in the bottom left corner for extra details. They're referencing the DS18S20 so perhaps this would be compatible with the Qkit/VK011 controller?

Any better ideas are also welcome :hesaid:

Thanks!!
 
While not flush mount these devices work excellently in bathrooms as you can not only control your heater but automate the exhaust fan using the humidity sensor. I use these with HomeSeer to fully automate my bathrooms. I put them behind the door to hide them from site. The issues I had with flush mount temp sensors is they read very low due to the colder air in the wall.
http://store.homeseer.com/store/HM-TS001--...es-P764C57.aspx
 
Back
Top