HAI automating setpoints for power failure

[EndureE]

Is there any way to set HAI setpoints through automation rather than the console?

I am using the outdoor humidity sensor to override the t-stat call for the humidifier when the outdoor humidity is high enough. But if power is reset, I have to go back to the console and reset the humidity setpoints manually. Is there any way to automate this so that on power loss, those setpoints go to a predetermined level? If not, is there a workaround to avoid manually resetting everything?

 

[dwalt]

Use the HAI programming capabilities, have it configure the setpoints daily and you don't need to figure out if there was a power failure.