Quick stupid question for all. I have an OmniPro II with two hardwire zone expanders installed. I have set the expansion module 1 and 2 to hardwire expander within PC Access. The zones all show up and can be named, etc. The issue is all of the expanded zones show a loop of ZERO and not ready no matter what happens. The on board zones all work fine, its just the expanded zones.
The ribbon cables are connected to the main controller and the address jumper is set on 1 for the first and 2 for the second.
Am I forgetting something or otherwise screewed up???
Thanks
The ribbon cables are connected to the main controller and the address jumper is set on 1 for the first and 2 for the second.
Am I forgetting something or otherwise screewed up???
Thanks