I'm very new to home automation. The home I purchased had this system built in and I was able to set up their previous GUI using SnapLink but I would much prefer using homekit. This plug in seems to be exactly what I need, however, it is not discovery any of my system. I have switches, thermostats, and alarm system. It also looks like it had a button button for the garage but that hasn't worked with snaplink. I'm hoping to start by mapping the light switches and then go from there. Any troubleshooting steps? my setup is below where address, port and keys match what's in the omni controller.
{
"name": "omni",
"address": "xxx.xxx.x.xxx",
"port": xxxx,
"key1": "xx-xx-xx-xx-xx-xx-xx-xx",
"key2": "xx-xx-xx-xx-xx-xx-xx-xx",
"includeAreas": false,
"includeZones": false,
"includeBypassZones": false,
"includeButtons": false,
"includeUnits": true,
"includeThermostats": false,
"includeEmergencyAlarms": false,
"includeAccessControls": false,
"includeAuxiliarySensors": false,
"setHomeToAway": false,
"setNightToAway": false,
"securityCode": "0827",
"includeHumidityControls": false,
"targetHumiditySetPointType": 1,
"targetHumidityDifference": 0,
"defaultAccessoryMappings": {
"zone": "none",
"zoneFireEmergency": "none",
"unit": "lightbulb"
},
"map": {
"units": {
"lightbulb": "2,4,5,10,18,20,26,42,58,34,35,50,66,74,82"
}
},
"garageDoors": [
{
"openTime": 10
}
],
"pushover": {
"alarms": {
"burglary": false,
"fire": false,
"gas": false,
"auxiliary": false,
"freeze": false,
"water": false,
"duress": false,
"temperature": false
},
"troubles": {
"freeze": false,
"batterylow": false,
"acpower": false,
"phoneline": false,
"digitalcommunicator": false,
"fuse": false
}
},
"mqtt": {
"showMqttEvents": false
},
"syncTime": false,
"showHomebridgeEvents": false,
"showOmniEvents": false,
"showRequestResponse": false,
"clearCache": false,
"forceAutoDiscovery": true,
"platform": "OmniLinkPlatform"
}