ok, I need to move all my video/satellite to a new can. I can't flush mount the can cause of wiring behind the spot beside the existing can. I was thinking of just surface mounting it, punch out a hole in existing can, cut hole in stud, route to new can.
Anyone else have better suggestions?
Also, I have the sheet from the installer that did the pre-wire for the security. The red line isn't marked as to waht it is, but I assume it's for smoke alarm? If so, how do you interpret this.
"31 Smoke: End of line/ In ceiling Bed 3 Hall"
"33 Smoke: Loop By Elec Smoke By MBed in ceiling"
Does that mean there is only one wire for 2 smokes?
Also there is a lamp cord type wire in my can that is not labelled. I think it is this...
"Power: 2 Car L/U Box"
WTH is that?
Also, I can't seem to find the interior siren wire, but the exterior was in the attic, so I mounted the Elk-73 in the attix. Is this ok as it is an indoor speaker? I mounted it close to a vent in the roof for max db.
That's it for now. Almost there!!
D
Anyone else have better suggestions?
Also, I have the sheet from the installer that did the pre-wire for the security. The red line isn't marked as to waht it is, but I assume it's for smoke alarm? If so, how do you interpret this.
"31 Smoke: End of line/ In ceiling Bed 3 Hall"
"33 Smoke: Loop By Elec Smoke By MBed in ceiling"
Does that mean there is only one wire for 2 smokes?
Also there is a lamp cord type wire in my can that is not labelled. I think it is this...
"Power: 2 Car L/U Box"
WTH is that?
Also, I can't seem to find the interior siren wire, but the exterior was in the attic, so I mounted the Elk-73 in the attix. Is this ok as it is an indoor speaker? I mounted it close to a vent in the roof for max db.
That's it for now. Almost there!!
D