Hi, based on this email thread, I am surprised that things may not of changed in a few years. Suggestions?
I have:
Leviton DZMX1-1LZ
Linear WD500Z-1
Leviton VRUSB-1US Vizia RF + Installer tool USB (latest software checked)
Leviton VRC0P-1LW Vizia RF + RS232 interface
Elk M1XSLZW
ELK MG1 firmware 5.3.0 with boot 3.3.6
RP2 2.0.24
I can do a link test between all combinations of the two controllers and the two switches, all check 100% after adding them.
Just can't do the association with either the two switches. I moved the secondary controller (VRC0P) two feet away from the switches to assure a good test signal. no luck. I plan to stay with Leviton, so not sure why it can't be associated.
thanks, Jay
I have:
Leviton DZMX1-1LZ
Linear WD500Z-1
Leviton VRUSB-1US Vizia RF + Installer tool USB (latest software checked)
Leviton VRC0P-1LW Vizia RF + RS232 interface
Elk M1XSLZW
ELK MG1 firmware 5.3.0 with boot 3.3.6
RP2 2.0.24
I can do a link test between all combinations of the two controllers and the two switches, all check 100% after adding them.
Just can't do the association with either the two switches. I moved the secondary controller (VRC0P) two feet away from the switches to assure a good test signal. no luck. I plan to stay with Leviton, so not sure why it can't be associated.
thanks, Jay