providince
Member
I just got the first of my inputs attached to the Elk, 3 wireless door sensors. This is currently the only thing connected. I did a test of arming and disarming and everything worked fine. About an hour after the test, when I just leave it be, I come back to the keypad and it gives me a not ready error. I can't arm or disarm the system.
If I turn the power on the Elk mainboard off and then back on, everything resets and I can arm and disarm the system but an hour later is starts giving me the not ready reading again.
Any ideas would be appreciated.
If I turn the power on the Elk mainboard off and then back on, everything resets and I can arm and disarm the system but an hour later is starts giving me the not ready reading again.
Any ideas would be appreciated.