I finally istalled a wired PIR in ZONE 8. I tokk 2 wires and hooked them to the power (it seems to be working fine as when I walk past the sensor the led turns on and if I stand really still it turns off.)
There are only 2 wires that come out fo the PIR other than the 2 for power. NC and C. I connected the NC to NEG of Z8 and the other to Z8.
I then wanted to arm zone8 to see what happens when i trigger it and it says "trouble zone 8 violated". I then went and checked the volatge for zone 8 and the volts are 0.00 meaning it is shorted. I also switched the Z8 wires and the same result.
What do I do? Is it power? How do I make this work.
Regards,
There are only 2 wires that come out fo the PIR other than the 2 for power. NC and C. I connected the NC to NEG of Z8 and the other to Z8.
I then wanted to arm zone8 to see what happens when i trigger it and it says "trouble zone 8 violated". I then went and checked the volatge for zone 8 and the volts are 0.00 meaning it is shorted. I also switched the Z8 wires and the same result.
What do I do? Is it power? How do I make this work.
Regards,