It works for me. You need the latest Homeseer beta... 2.1.88.
And you need a z-wave switch that supports associations. I have an 800-watt ACT dimmer that does this. With HS 2.1.88, I can establish an association (group 1)between the switch and homeseer. When this is done, turning the swtich on or off instantly communicates it's status to hs. no need for polling, which i have turned off for the device.
also good, i can now establish other associations between the switch and other devices. (groups 2 and 3).
the 800-watt dimmer was purchased months ago after i went through 2 of the zdw120s. Could not get them to work properly. They seemed to go to sleep periodically, then went belly-up for good.
And you need a z-wave switch that supports associations. I have an 800-watt ACT dimmer that does this. With HS 2.1.88, I can establish an association (group 1)between the switch and homeseer. When this is done, turning the swtich on or off instantly communicates it's status to hs. no need for polling, which i have turned off for the device.
also good, i can now establish other associations between the switch and other devices. (groups 2 and 3).
the 800-watt dimmer was purchased months ago after i went through 2 of the zdw120s. Could not get them to work properly. They seemed to go to sleep periodically, then went belly-up for good.