Recent content by AO-Brandon

  1. Automated Outlet HAI

    Automated Outlet HAI

    Installation of the HAI system at Automated Outlet by Brandon Stapp
  2. A

    Removing dead Z-Wave modules?

    The pro version of ControlThink will allow you to remove or replace dead nodes.
  3. A

    UPB and Omni with multiple Main Panels

    if you use the ELK-IP232 connected directly to the serial port of the HAI set in "server" mode and one ELK-IP232 connected to a PIM on each panel set in "client" mode, you will be able to communicate. It allows you to trick the HAI, it still thinks that only one PIM is connected, but both of...
  4. A

    taping IR Emitters

    as long as they are all the same type / voltage IR recievers, you can run them into an IR hub and have a single "summed" output. Something like the Buffalo Electronics IR-J8 would work perfectly!
  5. A

    info wanted

    Thanks for the referral! We are always happy to help!
  6. A

    How to detect an oil leak?

    could you monitor the pressure of the line instead? the other option may be to use a drip pan with a float.
  7. A

    New HAI Omni Pro 2 system and need help

    Welcome to CocoonTech! Depends on what you want for your final product, the customization ability in the 5.7e is phenomenal! That is correct, if you want more than 4 cameras, you will need multiple camera servers. You can however use just about any camera you want as long as it is an analog...
  8. A

    What do you do when your alarm goes off in the middle of the night?

    <- Born and bred Texan. I roll out of bed, get into the closet, get the gun out of the safe and clear the house. It's a programmed response I don't even think about.
  9. A

    Media cabinet power

    Currently I only know of a 12VDC version, but the IEC plug on it (accessory cord here) can be used to power a separate power supply if needed. According to the tech sheet it is capable of putting out 40 watts / 3.3 amps max. There is also a single gang module for those with a Channel Vision...
  10. A

    Media cabinet power

    Little late to the party, but I use these.
  11. A

    Sacedog's House Wiring Project

    Yep, did it on all of our panels here, at Martin's house, and at my house. Fell in love with it about three years ago when I rewired the ELK system that was in our building at the time. Check it out here!
  12. A

    Sacedog's House Wiring Project

    ;) Crap. Now I have to go rewire all of my stuff. :P
  13. A

    Another surge protection question...

    We have seen a lot of success with the HT500PC by TrippLite. I usually include at least one in every bid that I do and they almost always end up with one per TV. HT-500PC - Product Overview Protection Type: EMI / RFI Plug/Connector Type: NEMA 5-15P...
  14. A

    qouestion about using fox and hound - broken wire

    The NuVo iPod dock is not actually a "network" device, and it will require all 4 pairs in the CAT 5e cable. I had a customer with a similar issue unfortunately ...
  15. A

    PC Access and Windows 7

    I have been running PC Access on my 64 bit Windows 7 computer since 3.0 was released. What version are you trying to install?
See more
Back
Top