X-10 stopped working for me yesterday, I installed the amp the day before. I checked my T103 interface; it seemed OK. I went to the new amp in the other building and saw it steadily flashing green as if it was in test mode. I didn't see any P1 on & offs in the HS log. I hit the test button twice but it still flashed.
I thought the problem may be a motion sensor flood, so I turned off a couple of them and HS events that hadn't fired played catch-up and X-10 was back. I did NOT go back and check the amp for flashing green.
This morning, no X-10 again.
I killed the 2 motion sensors again to no avail. I went back to the amp. It was still flashing. I power cycled it this time and X-10 came back. There were no catch-ups this time.
All is well again.
Could a motion sensor cause this behavior or could the unit be defective or both? I see no evidence of a motion sensor flood in the HS logs; usually a bunch of M?s, as I recall.
I thought the problem may be a motion sensor flood, so I turned off a couple of them and HS events that hadn't fired played catch-up and X-10 was back. I did NOT go back and check the amp for flashing green.
This morning, no X-10 again.
I killed the 2 motion sensors again to no avail. I went back to the amp. It was still flashing. I power cycled it this time and X-10 came back. There were no catch-ups this time.
All is well again.
Could a motion sensor cause this behavior or could the unit be defective or both? I see no evidence of a motion sensor flood in the HS logs; usually a bunch of M?s, as I recall.