DeputyDawg
Member
I have a OmniPro II Controller 3.6A and Dealer PC Access with update 3.15.0.803. I added the Omni Notifier Board 20A30-1 and the interface Jumper is set to "232" with the modular cable in Serial Port 2.
The instructions tell me to Go to Expansion/Serial/Serial 2/and use the drop down menu to click on "E-Mail Board". That term "E-Mail Board is not in the drop down menu.
I've done a Read from Controller.
I'm using Firmware 3.13 or later (3.15.0.803).
Suggestions?
The instructions tell me to Go to Expansion/Serial/Serial 2/and use the drop down menu to click on "E-Mail Board". That term "E-Mail Board is not in the drop down menu.
I've done a Read from Controller.
I'm using Firmware 3.13 or later (3.15.0.803).
Suggestions?