No - revisions are kind of vague relating only to the network TCP connection handling.
PC Access Version 3.14.1.759 (27/October/2014)
- Controller firmware 3.14a released:
- Improved TCP connection handling.
- OmniTouch 7 firmware 1.7 released.
- Improved TCP connection handling.
- Added Pop-Up Camera support. * This does not work any more with the Omnitouch 5.7/5.7e's (maybe only with the Omnitouch 7)
- Added Dealer Info support.
- Fixed problem where E-Mail Notifier Board MAC address could be changed during a firmware update.
Personally my issues came before V3.14 of the firmware. Initially the concern did occur once or twice over the span of about 2 years. I did also increase the number of devices on the network.
Historically for me the working solution was to remove the network cable from the NIC on the OPII board for a day or so then plug it back in. Think I mentioned here a few years back.
Here too as others I did have issues (random panel resets) with the first firmware posted relating to the added email board. I cleared my panel and reloaded my stuff and all was fine afterwards.
The reset issue can be that stuff too. I do not have an email board in my OPII.
In a recap a I see a couple of concerns over the last few years:
1 - NIC thing (disconnectivity, time sync off, serial com issues) - this never caused a reset of my panel; just a NIC disconnect.
2 - updated firmware for
Email board - this caused random resets for me until I cleansed my board (cold / reuploaded my configuration). Note that the resets also cause the network port to disconnect.
The updated firmware for the Omni Notifier
email board was Controller firmware 3.13 release.
Looking at old threads and my posts here I did have that bouncy reset stuff happening between FW 3.12 going to FW 3.13 (which would also cause a network disconnect).
@SJHart - your bouncing issue may be related to #2 above?