Hi there.
I could use a little help with UPB lighting.
I have downloaded latest upstart (5.2 build 23) from Pulseworx site and I am using a SA UMC-USB-W. I can configure ANY new HAI switch or SA plug in modules but I cannot configure either the ELK M1PCSPIM or ANY of the HAI scene controllers I have.
The HAI scene controllers simply do not respond to the Find Module in Setup. I have installed several directly beside several HAI switches and the controller can turn all lights on and off it seems by default. I just cant find it with upstart. Any ideas?
Next, I can't seem to connect to the ELK M1PCSPIM. Upstart will find the PIM but always fails before completing. It fails at various points. I am confused as I see the signal meter down below go full green bars, then full red bars back and forth but the tests show good quality. When it fails, I see red bars come and go for 4 attempts.
Noise at PIM is 0/0/0 ; Noise at device is 0 ; Signal level at PIM is 30 ; Signal level at device is 58
BTW, an SA UMA-20 connected to same outlet ALWAYS connects WITHOUT EVER seeing any red at the signal bar down below. I have tested this many times.
Any ideas???
Thanks for any help!
I could use a little help with UPB lighting.
I have downloaded latest upstart (5.2 build 23) from Pulseworx site and I am using a SA UMC-USB-W. I can configure ANY new HAI switch or SA plug in modules but I cannot configure either the ELK M1PCSPIM or ANY of the HAI scene controllers I have.
The HAI scene controllers simply do not respond to the Find Module in Setup. I have installed several directly beside several HAI switches and the controller can turn all lights on and off it seems by default. I just cant find it with upstart. Any ideas?
Next, I can't seem to connect to the ELK M1PCSPIM. Upstart will find the PIM but always fails before completing. It fails at various points. I am confused as I see the signal meter down below go full green bars, then full red bars back and forth but the tests show good quality. When it fails, I see red bars come and go for 4 attempts.
Noise at PIM is 0/0/0 ; Noise at device is 0 ; Signal level at PIM is 30 ; Signal level at device is 58
BTW, an SA UMA-20 connected to same outlet ALWAYS connects WITHOUT EVER seeing any red at the signal bar down below. I have tested this many times.
Any ideas???
Thanks for any help!