Zigbee ZIM installation instructions:
INSTALLATION
The Leviton controller connects to the ZigBee network by using a Model 81A00-3ZB ZigBee Interface Module (ZIM). Set the jumper on the controller serial port to the “485” position. Set the Serial Function for the serial port on the Leviton controller to ZigBee.
The ZIM serves as the coordinator for the ZigBee network. Individual ZigBee devices need to be enrolled through the coordinator before they may participate in the ZigBee network. When a device is enrolled in the ZigBee network, it is assigned a unique four digit address by the coordinator. This address is used by the Leviton controller to access the device. ZigBee devices may also be disbanded through the coordinator to remove them from the network.
Devices may be enrolled or disbanded by using the ZIM directly, by using an Omni or Lumina console to command the ZIM, or by using PC Access software to command the ZIM. The recommended method is to use PC Access software to ensure that the ZigBee addresses are stored in the PC Access account file.
Installation Using PC Access
First, connect to the Leviton controller using the PC Access software.
To set up units, set the House Code Format for the desired units in the Leviton controller to ZigBee. Now click on the button in the “Address/Node ID” column for the desired unit. If the address is non-zero, a ZigBee device has already been enrolled for the unit. If this is not the correct device, press the “Disband” button in the dialog box to disband the current device. After any existing device has been disbanded, place the new ZigBee device in the enrollment mode by following the instructions for the device. Then press the “Enroll” button in the dialog box to enroll the new device. If the enrollment process is successful, the ZigBee address for the device will be shown.
Follow a similar process for thermostats. First, set the thermostat type for the thermostat to “Auto Heat/Cool”, “Heat/Cool”, “Heat Only”, or “Cool Only” as appropriate. Click on the button in the “Protocol/Address” column for the desired thermostat, set the protocol to “ZigBee”, place the thermostat in the enrollment mode, and enroll the thermostat by pressing the “Enroll” button.
Note that if PC Access is not connected to the Leviton controller, the “Enroll” and “Disband” buttons will be disabled. ZigBee addresses may be manually entered if the ZigBee network has been previously configured by using the ZIM directly.
Installation Using Console
An Omni or Lumina console can be used to initiate enroll and disband operations at the ZIM.
To set up units, set the House Code Format for the desired units in the Leviton controller to ZigBee. Press “#” twice when displaying the status of the desired unit. Select “Disband” to disband any ZigBee device currently assigned to the unit. Place the new ZigBee device in the enrollment mode and then select “Enroll” to enroll the new device.
Follow a similar process for thermostats. First, set the thermostat type for the thermostat to “Auto Heat/Cool”, “Heat/Cool”, “Heat Only”, or “Cool Only” as appropriate. Press “#” twice when displaying the status of the desired thermostat. Select “Disband” to disband any ZigBee device currently assigned to the thermostat. Place the new ZigBee device in the enrollment mode and then select “Enroll” to enroll the new device.
After enrolling or disbanding a ZigBee device remember to use PC Access to read from the controller so that the ZigBee addresses can be saved in the PC Access account file.
Installation Using ZIM
Follow the instructions for the ZIM to manually configure the ZigBee network. Record the ZigBee address for each ZigBee device enrolled at the ZIM and then enter these addresses manually into PC Access as described above.
PDF Zigbee Manual
Omnistat2 Zigbee Integration manual