Hello!
I am quite new to using 1-wire sensors to build up a weather station.
I have the 1-wire USB adaptor, 4-channel hub, anemometer controller board with the Inspeed anemometer and wind-wane, 1 temperature sensor, 1 barometer and 1 humidity/temp sensor. I also purchased the universal AC adaptor.
I am using Weather Display, and am having some trouble to work out how to get input from all sensors. It seems as the Dallas 1-wire reader is only able to get data from the temperature sensor and anemometer controller board.
When I connect the barometer I get a ROM ID, the same also with the humidity/temp sensor.
Question: Should the humidity/temp sensor give me 1 or 2 ROM IDs? When I connect the anemometer controller board I get 2 ROM IDs, one for the speed and one for direction. But for hum/temp I only get one ID.
I do not manage to get any data from the barometer when I enter the ID into the barometer field. I have read that I have to enter the barometer V max and min and hpa max and min. Were do I get these values? Have written hobby-boards, but no response.
Anyone also who can tell me where in the Dallas 1-wire reader I should enter the different sensors ROM ID?
One final question - anyone who know if it possible to get a 1-wire solar sensor and UV-sensor that I can connect to my 1-wire network? Have asked HB the question by e-mail, but also there no response.
Kriz
I am quite new to using 1-wire sensors to build up a weather station.
I have the 1-wire USB adaptor, 4-channel hub, anemometer controller board with the Inspeed anemometer and wind-wane, 1 temperature sensor, 1 barometer and 1 humidity/temp sensor. I also purchased the universal AC adaptor.
I am using Weather Display, and am having some trouble to work out how to get input from all sensors. It seems as the Dallas 1-wire reader is only able to get data from the temperature sensor and anemometer controller board.
When I connect the barometer I get a ROM ID, the same also with the humidity/temp sensor.
Question: Should the humidity/temp sensor give me 1 or 2 ROM IDs? When I connect the anemometer controller board I get 2 ROM IDs, one for the speed and one for direction. But for hum/temp I only get one ID.
I do not manage to get any data from the barometer when I enter the ID into the barometer field. I have read that I have to enter the barometer V max and min and hpa max and min. Were do I get these values? Have written hobby-boards, but no response.
Anyone also who can tell me where in the Dallas 1-wire reader I should enter the different sensors ROM ID?
One final question - anyone who know if it possible to get a 1-wire solar sensor and UV-sensor that I can connect to my 1-wire network? Have asked HB the question by e-mail, but also there no response.
Kriz