PCS, creators of UPB, considering offering HAI OmniPro repair service, input needed!

[planorich]

I have some Omnitouch 5.7 screens but I don't have the RJ45 pigtail that comes with the unit. Does anyone know the wiring of the 4 leads into the 8 pin RJ45?

 

[leeleses]

The 53A00-2 is standard ethernet wiring plug n play.

If you have the 53A00-1 I'll have to look for that.

 

[leeleses]

This explains some of it if not all.

HAI Omnitouch 53A00-1 Sensitivity

I acquired my very first 53A00-1 (used) and I'm testing it. Firmware version is 2.3.5 I was able to calibrate it without any problems, and it's running well except for the screen's sensitivity to touch. It works fine with the pencil eraser and with a fingernail, but does not respond to a...

cocoontech.com

 

[leeleses]

53A00-1 Install Manual, wiring at the end...

 

[dan_n]

I assume we need to find a source of these chips? If China is unreliable, could we build a list of pc networking cards using this chip?
A quick check on ebay shows the Realtek Ethernet Card 460-0139-003 as an example...

Before ordering RTL8019AS ethernet chips from China I checked all the boards in my scrap box to see if any had it but none did. Today I found an old Netgear RP114 router I had bought in 2002 and it does have the RTL8019AS chip. Could have swapped the chip over to the OP2 without waiting 2.5 weeks.

 

[myyaz33]

Anything ever happen here? PCS ever do any repairs? Looks like martin responded then dissappeared. Same with RobinsonNI, was anyone ever able to purchase a board from him? Wondering if Leviton came after them for IP rights...